Question 1

What is the difference between A-coded and B-coded M8 connectors, and how do I choose?

Accepted Answer

A-coded M8 connectors are the default choice for most sensor and actuator wiring, especially standard DC I/O signals. B-coded M8 connectors use different keying and pin assignment intent to prevent accidental cross-connection in control or communication circuits. Selection should be based on the device port specification, not just pin count. Always match coding, gender, and pole count exactly to avoid mechanical incompatibility and wiring errors.

Question 2

Do I need shielded cable for M8 open ended sensor connections?

Accepted Answer

Shielding depends on signal type, cable routing, and electromagnetic environment. For simple 24 VDC discrete sensors in short runs, unshielded cable is often acceptable. For analog signals, fast switching loads nearby, VFD environments, or long cable routes, shielded cable can significantly improve signal integrity and EMC performance. Follow the device manufacturer’s grounding guidance, especially where single-point vs. multi-point shield termination affects noise behavior.

Question 3

What IP rating can I expect from an M8 open ended cable assembly?

Accepted Answer

The IP rating applies primarily to the connector interface when fully mated with a compatible counterpart and correctly tightened. Industrial M8 interfaces are commonly used in IP67 installations, with higher ratings possible depending on connector design. The open cable end itself is not inherently sealed and must be protected in the control cabinet or junction box. Always confirm system-level ingress protection, not connector datasheet values alone.

Question 4

How do I select the correct cable length for an M8 open ended cable?

Accepted Answer

Start with the physical route length, then add allowance for service loops, moving axes, and maintenance access. Avoid excessive slack near moving equipment, but do not design to exact minimum length because connector strain and bend radius become problematic. For low-level signals, longer runs may increase voltage drop susceptibility and noise pickup, so verify electrical limits. Standardizing a few approved lengths can simplify spares and reduce installation errors.

Poles	Coding	Protection	LED
6-pole	B	IP65	No
6-pole	B	IP65	No
6-pole	B	IP65	No
6-pole	B	IP65	No

Open Ended Cable - 6

M8 Round Plug Connector Open Ended Wire 90° Male 908362

M8 Round Plug Connector Open Ended Wire Straight Male 908361

M8 Round Plug Connector Open Ended Wire Straight Female 908463

M8 Round Plug Connector Open Ended Wire 90° Female 908462